fv_dlg-dcl.md — Field Verification Dialog (v7.0)

File: fv_dlg.dcl
Version: v7.0
Category: Dialog Definitions
Size: 5.7 KB (173 lines)

Note

Mobile Field Verification

Site measurement verification with v7.0 mobile app, AR measurement, photo AI analysis, and automatic design updates.

v7.0 Enhancements

  • ? Mobile app integration (tablet/phone field data capture)

  • ? AR measurement (augmented reality tape measure)

  • ? Photo AI analysis (extract dimensions from photos)

  • ? Auto-design updates (cloud sync, instant panel adjustments)

  • ? GPS location tagging (automatic positioning)

Typical Workflow

1. Field crew at site with tablet
2. Open fv_dlg mobile app
3. Measure opening: Point phone camera
4. AR overlay shows: "3'-7" wide (design was 3'-6")
5. Crew confirms: Tap ?
6. Photo captured with measurement
7. GPS tagged: Grid B-3, Floor 2
8. Upload to cloud (instant sync)
9. Office receives notification:
   "Field variance: Opening +1" at Grid B-3"
10. Engineer reviews, clicks [Update Panel]
11. Panel P-205 auto-adjusted to 3'-7" opening
12. Fabrication prevented with wrong dimension!

AR Measurement (NEW)

Augmented Reality:

Crew points phone at opening:
AR overlay appears:
- Vertical edges detected (yellow lines)
- Width calculated: 43" (3'-7")
- Height calculated: 85" (7'-1")
- Diagonal check: Square within 1/4"

Tap to confirm ? Data captured
No tape measure needed!
Faster, more accurate

Photo AI Analysis

Dimension Extraction:

Crew takes photo of opening
AI analyzes image:
- Edge detection
- Scale calibration (known reference)
- Dimension extraction
- Verification checks

"Opening: 3'-7" × 7'-1" (±1/4")"
"Confidence: 98%"

If confidence < 90%: Request manual measurement
Otherwise: Accept automatically

Cloud Synchronization

Real-Time Updates:

Field measurement ? Cloud ? Office (instant)

Office designer sees:
"New field data: Grid B-3"
Click to review ? Photo + measurements shown
[Accept] ? Panel updates automatically
[Reject] ? Request re-measurement

All changes tracked in revision log
No email/phone calls needed!

GPS Location Tagging

Automatic Positioning:

Field measurement captured:
GPS: 47.6062° N, 122.3321° W
Matched to BIM model: Grid B-3, Floor 2
Panel: P-205 (auto-identified)

Crew doesn't need to enter:
- Grid location (auto-detected)
- Floor number (GPS altitude)
- Panel number (BIM correlation)

Just measure and go!

Enhancement Status: ? v7.0 ENHANCED [10/38]

End of Document